When your garage door starts to look worn out, do not start to look at replacements just yet. In fact, you can opt to provide your garage with a totally fresh look with a new coat of paint. Before breaking out the rollers and paint cans, it is essential to know that exterior painting is definitely not similar to painting your home’s walls. Below are the guidelines you need to consider to properly paint your garage door.
Inspect the weather
Apparently, your outdoor painting project will be most likely dependent on the weather compared to repainting your room indoors. Hence, make sure to inspect the weather and attempt to only paint any painting projects you have in your home on a clear and cool day. The perfect conditions would be if the temperature remains between 50-75 F° with indirect sunlight, low wind, and low humidity. As much as possible, attempt to search for 3 days in a row that have these conditions on weather forecasts you can see on the internet or news.
Get the materials
You will need a gallon of both the primer and the paint for a garage door that can fit 2 vehicles. Bit, when you plan to cover dark colors with lighter ones, you probably need to get a little more. Also, here are the other materials that you need:
- All-purpose cleaner
- Clean rags
- Drop cloth
- Fine sandpaper
- Nylon paintbrush (preferably 2 inches)
- Paint roller (preferably ¾ inch)
- Painter’s tape
- Ladder or step stool
- Wire brush
Prepare the door
You cannot begin to paint a garage door immediately. It is expected to have tons of rust, grit, grime, and dirt compared to your inside walls. Hence, it will require tons of prep work. Scrub off any chipped or rusted areas using your wire brush. Then, using sandpaper, sand those affected spots to make a smooth base.
After doing this, clean the whole room with a sponge and an all-purpose cleaner. Use your garden hose to rinse it and then allow the surface to dry with clean rags or towels. Allow the door to finish air-drying for approximately 1 hour.
Cover and tape
As your door dries, try to cover up anything you do not want to be pained on, which includes taping any hardware and trim that you don’t plan to paint. Also, you can put down a drop cloth to avoid staining your concrete. Apart from that, you may need to think about disengaging your lift motor for you to lower and raise your garage door as required as you work.
Begin by priming your garage door’s inset panel using your paint roller or paintbrush. As you paint the trim, make sure to save this for last. Allow it to dry for about twelve hours.
This is the time when you have to apply the paint color of your choice. Make sure to start your way from the top to the bottom. If you don’t know how to properly do this, ask for the help from the expert painters Carson City NV today.